en to en translation catalogue (6 entries)

en: gluon-config-mode:welcome
en: Welcome to the setup wizard of your new Freifunk Freifunk Ruhrgebiet West node. Please fill out the following form and submit it.

en: gluon-config-mode:domain
en: Domain

en: gluon-config-mode:domain-select
en: Here you have the possibility of selecting the mesh domain in which your node is placed. Please keep in mind that your router only connects with the nodes of the selected domain.

en: gluon-config-mode:pubkey
en: <p>This is your Freifunk node's public key. The node won't be able to connect to the mesh VPN until the key has been registered on the Freifunk servers. To register, send the key together with your node's name (<em><%=pcdata(hostname)%></em>) to <a href="mailto:kontakt@freifunk.ruhr?subject=<%= urlencode('Registration: ' .. hostname) %>&amp;body=<%= urlencode('# ' .. hostname .. '
    # ' .. sysconfig.primary_mac .. '
    key ') %>%22<%= pubkey %>%22;<%= urlencode('
    
    I have taken note that the contact I entered in the ') %><%= urlencode('node is publicly available on the Internet and can be ') %><%= urlencode('used by any services (e.g. the meshviewer map).') %><%= urlencode('
    
    Thanks, 
    
    ') %>">kontakt@freifunk.ruhr</a>. Of course, your e-mail address will be treated confidentially and will not be passed on.</p><div class="the-key"> # <%= pcdata(hostname) %><br /><%= pubkey %></div><p>Your node <em><%= pcdata(hostname) %></em> is currently rebooting and will try to connect to other nearby Freifunk nodes via WLAN and to a VPN-gateway via your internet connection after the reboot is finished.</p><p>Don't forget to plug the network cable from the LAN port to the WAN port.</p>

en: gluon-config-mode:novpn
en: <p>You have selected <strong>not</strong> to use the mesh VPN. Your node will only be able to connect to the Freifunk network if other nodes in reach already have a connection.</p>Please send an e-mail with the name of your node (<em><%=pcdata(hostname)%></em>) and some additional information to <a href="mailto:kontakt@freifunk.ruhr?subject=<%= urlencode('Registration: ' .. hostname) %>&amp;body=<%= urlencode('# ' .. hostname .. '
    # ' .. sysconfig.primary_mac .. '
    key ') %>%22<%= pubkey %>%22;<%= urlencode('
    
    I have taken note that the contact I entered in the ') %><%= urlencode('node is publicly available on the Internet and can be ') %><%= urlencode('used by any services (e.g. the meshviewer map).') %><%= urlencode('
    
    Thanks, 
    
    ') %>">kontakt@freifunk.ruhr</a>. Of course, your e-mail address will be treated confidentially and will not be passed on.</p><p>Your node <em><%= pcdata(hostname) %></em> is currently rebooting and will try to connect to other nearby Freifunk nodes after that.</p>

en: gluon-config-mode:reboot
en: <p>For more information about the Freifunk community on Freifunk Ruhrgebiet West, have a look at <a href="https://freifunk.ruhr/" target="_blank">our homepage</a>.</p><p>To get back to this configuration interface, press the reset button for about 10 seconds during normal operation. The device will then reboot into config mode.</p><p>Have fun with your node and exploring of the Freifunk network!</p>
